New install for ASUS TUF Gaming Z790-Plus WiFi D4 w/i7-13700K CPU

[D-an-W]

Yes - See post #26 page 3 of this thread for the fix that worked for me and others too!

I had that enabled already and have tried it disabled, do you change any settings in Ventura (Sleep in Windows works ok)?

 

[MrMinimizer]

I had that enabled already and have tried it disabled, do you change any settings in Ventura (Sleep in Windows works ok)?

here's mine: settings->Energy Saver

 

[D-an-W]

Thanks, I did have it set the same. I need to have a read up and see how to work it out. I do see a bluetoothd crash report after I attempt to put the system to sleep.

 

[Leesureone]

Thanks, I did have it set the same. I need to have a read up and see how to work it out. I do see a bluetoothd crash report after I attempt to put the system to sleep.

[email protected], instant wake from sleep sounds like your USB ports aren't mapped correctly. That's pretty typical behavior along with failure to wake from sleep or crashing.

 

[D-an-W]

[email protected], instant wake from sleep sounds like your USB ports aren't mapped correctly. That's pretty typical behavior along with failure to wake from sleep or crashing.

Thanks, I will look into it hopefully this weekend. I think I am on a different BIOS version to @MrMinimizer, could that alter mappings?

 

[Leesureone]

Thanks, I will look into it hopefully this weekend. I think I am on a different BIOS version to @MrMinimizer, could that alter mappings?

Its possible but not likely, best to map your own ports.

 

[D-an-W]

Yeah I will, when starting with a pre done EFI do I need to remove anything first?

I found the info I need I think!

 

[MrMinimizer]

Thanks, I will look into it hopefully this weekend. I think I am on a different BIOS version to @MrMinimizer, could that alter mappings?

I would think the bios version would “not” make any big difference of the usb mapping

FYI, on mine, i have the fenvi card usb plugged in the bottom left usb header and the nzxt usb header extension hub on the right with the AIO cooler plugged into the nzxt header hub and the Corsair commander pro light/fan controller plugged into the nzxt hub.

 

[D-an-W]

I would think the bios version would “not” make any big difference of the usb mapping

FYI, on mine, i have the fenvi card usb plugged in the bottom left usb header and the nzxt usb header extension hub on the right with the AIO cooler plugged into the nzxt header hub and the Corsair commander pro light/fan controller plugged into the nzxt hub.

I have a slightly different with the Corsair USB hub so will report back when I have had a go with USB mapping.

 

[D-an-W]

I would think the bios version would “not” make any big difference of the usb mapping

FYI, on mine, i have the fenvi card usb plugged in the bottom left usb header and the nzxt usb header extension hub on the right with the AIO cooler plugged into the nzxt header hub and the Corsair commander pro light/fan controller plugged into the nzxt hub.

I assume your USB map was done when connected like this?