Multibeast question

[oger]

Can I actually select options in Multibeast like enable SATA and eSATA at the same time?
Can I enable trim support even though I have no SSD installed yet. I just don´t want to break anything.
Is it correct, that Multibeast will never delete anything, just install?
Can I revert the changes made if things go wrong?

 

[Bob_the_Tomato]

Can I actually select options in Multibeast like enable SATA and eSATA at the same time?

On my board this is a hardware issue. One of my SATA ports will not work with an mSATA plugged in... but I think that eSATA is ok. Sorry I can't be more clear, my only eSATA drive is hooked up to my TiVo not my PC.

Can I enable trim support even though I have no SSD installed yet. I just don´t want to break anything.

Just buy an SSD that does not require TRIM support. They're out there, it's a function of the logic controller built into the SSD.

Is it correct, that Multibeast will never delete anything, just install?

Partially correct. MB will overwrite any older versions of KEXTs with the new ones if selected. This is just like Congress works... they can never repeal a law - just replace it with another law.

Can I revert the changes made if things go wrong?

This is where a good backup would come in. There is no "UNDO" in Multibeast.