Multibeast Help

[KenyanThegi]

First off, let me apologise if I've posted this in the wrong section... First post on this forum and first Hackintosh I'm working on. I've searched the forum for information but nothing has helped me solve my problem yet... any help would be very much appreciated!

To my problem:
I've successfully installed Mountain Lion 10.8.2 but seem to have trouble configuring Multibeast properly.
My specs are as follows:

Gigabyte Z77-DS3H Mainboard
32 GB RAM
256 GB SSD
Gainward GTX 580 (3GB)
Intel I7- 3770

Can anybody recommend the best settings to get this system up and running?

Also, on a different note, is there any way of getting the onboard graphics card fully enabled?

Thanks in advance!

 

[madsc13n41s4]

I'm having the same issues it seems.

Z77-DS3H rev 1.1 F10f
i3-3225
3GB Kingston RAM
1TB WD Caviar
HD4000 Graphics

Here's what I've done:

Make UniBeast USB from 10.8.0
Install 10.8.0 from USB
Boot 10.8.0 from USB and proceed through Welcome setup
Backed up with TimeMachine << This saves me alot of time just restoring the drive state instead of a 40 minute install. From here, I can try different MultiBeast settings from the same exact point by restoring from UniBeast USB.

The problem I'm having is finding successful settings in MultiBeast to fix what seem to be common HD4000 and sound issues, while leading to a successful HDD boot.