Contribute
Register

Mojave wont install. Does somebody know what this Verbose Mode says?

Status
Not open for further replies.
Thanks i will try that out.
 
Which should i keep?
You don't need the sensors while you are installing.
You only need the kext that matches your Ethernet interface - The other ones can go.
You don't have a 200 series motherboard.
The only one that you absolutely must have is FakeSMC.kext.
You probably need USBInjectAll.kext too - Check the guide that I linked.
 
image.jpg
So now everything worked after i tried it like the instructions but now i‘m stuck at the Step 2 of installation after rebooting. It says „About 15 minutes remaining“ but the status bar doesnt progress since about half an hour. Also the same Problem occured after rebooting again.
 
So now everything worked after i tried it like the instructions but now i‘m stuck at the Step 2 of installation after rebooting. It says „About 15 minutes remaining“ but the status bar doesnt progress since about half an hour. Also the same Problem occured after rebooting again.
Boot in verbose mode.
 
Can the cause be that i’m using a older Clover Version? (4674)
 
B66CFEF6-1AFF-49A0-A200-F9586248F088.jpeg
FDCE2DC0-F0CC-44AD-AFA6-621AED030659.jpeg
15AEE042-B308-4B89-9F83-386E7C9C564C.jpeg
87BB5DF5-34B8-4B5B-AA76-81DAAF2A56DD.jpeg
4803584D-6ED4-4708-BEFA-F71BF191ABF3.jpeg
11B17D81-895F-4562-9404-F616F3ECE431.jpeg
13ED15AC-5F26-4DA5-B9AE-A8B1DE9DEF1D.jpeg
455AE392-5AFC-488E-B24B-858719368093.jpeg
does this help? i hope it helps:S
 
does this help?
Not really, pictures of it working are pretty pointless - We need to see the kernel panic when it stops.

BTW why are you disabling Nvidia graphics ? According to your profile you don't have any.
 
Nvidia Graphics was autodisabled so i didnt touch it, should i enable it?
I have set nvidia to vesa checked but it doesn show in the picture because of brightness.
 
Status
Not open for further replies.
Back
Top