- Joined
- Aug 28, 2016
- Messages
- 133
- Motherboard
- Gigabyte Z390 Gaming SLI
- CPU
- i7-8700
- Graphics
- Vega 56
- Mobile Phone
-
Hi everyone!
I know there are some designers here, I'm trying to finish installing my wife's old Bamboo Fun board (model CTE650).
So far it's been easy downloading and installing the driver, and after allowing control permissions in the Security and Privacy from the System Preferences I could get it to work.
I can control and draw on Adobe Illustrator click on the icons, pretty much what I need and what I was expecting from it. However, I can not get the bamboo preferences pane to work. I would like to re map the buttons on the board.
I've been reading some posts but most of them are regarding the Wacom tablets (which I didn't know they were capable of running OSX by the way) But there is not much about digitizing boards.
Has any of you experience with this kind of hardware?
As always, thanks a lot for your valuable support.
Cheeers.
I know there are some designers here, I'm trying to finish installing my wife's old Bamboo Fun board (model CTE650).
So far it's been easy downloading and installing the driver, and after allowing control permissions in the Security and Privacy from the System Preferences I could get it to work.
I can control and draw on Adobe Illustrator click on the icons, pretty much what I need and what I was expecting from it. However, I can not get the bamboo preferences pane to work. I would like to re map the buttons on the board.
I've been reading some posts but most of them are regarding the Wacom tablets (which I didn't know they were capable of running OSX by the way) But there is not much about digitizing boards.
Has any of you experience with this kind of hardware?
As always, thanks a lot for your valuable support.
Cheeers.
