- Joined
- Sep 11, 2010
- Messages
- 23
- Motherboard
- Gigabyte Z370N Wifi
- CPU
- i5 8400
- Graphics
- HD630
- Mac
- Mobile Phone
I had a fully working 10.14.0 install on Gigabyte Z370N wifi using HD630 video and custom SSDT for USB support. In preparation for updating to 10.14.2, I updated Clover to the latest build (4798), then installed the 14.2 update. After update reboots were complete, my system will not boot into Mojave. Verbose boot indicates that "End RandomSeed" is the last event before video sleeps, then a reboot occurs about 30 seconds later. I am sure there is boot activity occurring during that 30 seconds, but I can't see it since display is dark.
Interestingly, I have a test build on a separate SSD in this system running 10.14.2 and Clover 4769 (from Multibeast 11). If I boot into this drive, Clover 4769 can see my production build and boots into it just fine, and everything is working normally. So I know my Mojave install isn't the issue (which is why troubleshooting files are not uploaded to this post)--I'm assuming Clover 4798 is messed up in some way. I have already tried reinstalling Clover to the production SSD and this does not correct the issue. I have not yet tried rolling back to an earlier version of Clover.
Any advice for where to start trouble shooting? Thanks in advance.
Interestingly, I have a test build on a separate SSD in this system running 10.14.2 and Clover 4769 (from Multibeast 11). If I boot into this drive, Clover 4769 can see my production build and boots into it just fine, and everything is working normally. So I know my Mojave install isn't the issue (which is why troubleshooting files are not uploaded to this post)--I'm assuming Clover 4798 is messed up in some way. I have already tried reinstalling Clover to the production SSD and this does not correct the issue. I have not yet tried rolling back to an earlier version of Clover.
Any advice for where to start trouble shooting? Thanks in advance.