Mac won't boot after using the 10.6.8 combo update

[TheIgnorant]

Hey everyone,
I decided to give Hackintosh a try, again, and I have ran into a problem.
As soon as I install the combo update, install MultiBeast and then reboot, the machine won't boot at all. Verbose shows it stops on [PCI configuration begin]. I've tried all the bootflags I could find for troubleshooting, but nothing changes. Any help?

Thanks in advance,
Theignorant_

 

[Going Bald]

Try with boot-args -v PCIRootUID =1 or -v PCIRootUID=0

Note these commands are case sensitive.

 

[TheIgnorant]

Try with boot-args -v PCIRootUID =1 or -v PCIRootUID=0

Note these commands are case sensitive.

Been there, done that. Nothing makes OSX boot after the combo update.
Bootflags I've used so far are -v, -x, PCIRootUID=0/1 and npci=0x2000/0x3000.
The only PCI card installed right now is my 9600GT. Note that before the update OSX boots normally without any bootflags.

 

[Going Bald]

try with nv_disable=1

 

[TheIgnorant]

try with nv_disable=1

I did it, again, didn't work.
Also, another problem I have is this: While I managed to get a bootable system with the 10.6.7 combo update, Chameleon won't boot my OSX install, it gets stuck after loading the FakeSMC keys. I'm using MultiBeast 3.10.1.