Contribute
Register

kextbeast doesnt seem to install kexts into folders

Status
Not open for further replies.
Do I leave those values in for BootConfig 0x28 and CsrActiveConfig 0x67, disabling SIP?

Or do I enable SIP and move the kexts to EFI and injectkexts in config?

I always keep SIP disabled as it is not possible to accurately predict when macOS/OS X will attempt to rebuild kernel cache.

It looks like im getting slow USB speeds. My usb 3.0 drive is writing 105 Mb/s and transfers data really slow.

Refer to the USB guide: https://www.tonymacx86.com/threads/guide-10-11-usb-changes-and-solutions.173616/
 
Do I leave those values in for BootConfig 0x28 and CsrActiveConfig 0x67, disabling SIP?

Or do I enable SIP and move the kexts to EFI and injectkexts in config?

Keep SIP disabled.

Keep the kexts in /L/E only. I think putting inside EFI is not a recommended way.
 
I always keep SIP disabled as it is not possible to accurately predict when macOS/OS X will attempt to rebuild kernel cache.



Refer to the USB guide: https://www.tonymacx86.com/threads/guide-10-11-usb-changes-and-solutions.173616/

I started running through that. Im new to this so I apologize in advance. I read through it a couple of times, but dont completely understand some of it.

I have a 9 series board

I did the EHCx->EH0x rename in the clover configurator

I have FakePCIID_XHCIMux.kext and FakePCIID.kext installed

I checked to make sure XHCI is named XHC and not XHC1

I have set XHCI to auto in BIOS


Im not sure if I need to use USB inject all. If I delete it and ioregistryexplorer shows XHC ports still there, then I dont need it?

I used this to get my computer readings my drives normally again without taking forever to load and randomly ejecting:
https://www.tonymacx86.com/threads/usb-new-raise-port-limit-patch-for-macos-10-12-sierra.202329/
 
I started running through that. Im new to this so I apologize in advance. I read through it a couple of times, but dont completely understand some of it.

I have a 9 series board

I did the EHCx->EH0x rename in the clover configurator

I have FakePCIID_XHCIMux.kext and FakePCIID.kext installed

I checked to make sure XHCI is named XHC and not XHC1

I have set XHCI to auto in BIOS


Im not sure if I need to use USB inject all. If I delete it and ioregistryexplorer shows XHC ports still there, then I dont need it?

I used this to get my computer readings my drives normally again without taking forever to load and randomly ejecting:
https://www.tonymacx86.com/threads/usb-new-raise-port-limit-patch-for-macos-10-12-sierra.202329/

If you need help, read guide post #1, "Problem Reporting".

Any any such questions are off-topic here. This thread is titled "kextbeast doesnt seem to install kexts into folder".
 
Status
Not open for further replies.
Back
Top