- Joined
- Aug 11, 2011
- Messages
- 58
- Motherboard
- Gigabyte Z390 Designare
- CPU
- i7-9700K
- Graphics
- EVGA GTX 1080; MSI RX 580 8GB
Trying to trouble shoot iMessage not working on my legacy install of High Sierra. Everything is working perfect except iMessage. I've done a a clean install about four times trying to get it working with no success.
The build:
GA-X58A-UD5 (rev2.0)
EVGA GTX 1080 FTW
High Sierra 10.13.1
RTL8111 en0 - ethernet cable plugged into en0
RTL8111 en1
iMac 14,2 definitions
Clover 2.4 r4509 (Legacy Install)
SmUUID and Hardware UUID are different, and stay the same after every boot.
ROM is the last 12 characters of SmUUID and is injected from Rt Variables ROM field.
MLB and Serial were both generated by Clover Configurator (5.1.2.0) and are injected from SMBIOS.
SmUUID was generated from uuidgen in terminal ran about ten times, and is injected from SMBIOS.
System Parameters has Inject System ID checked and Custom UUID field is left blank.
Questions I'm looking for answers:
The build:
GA-X58A-UD5 (rev2.0)
EVGA GTX 1080 FTW
High Sierra 10.13.1
RTL8111 en0 - ethernet cable plugged into en0
RTL8111 en1
iMac 14,2 definitions
Clover 2.4 r4509 (Legacy Install)
SmUUID and Hardware UUID are different, and stay the same after every boot.
ROM is the last 12 characters of SmUUID and is injected from Rt Variables ROM field.
MLB and Serial were both generated by Clover Configurator (5.1.2.0) and are injected from SMBIOS.
SmUUID was generated from uuidgen in terminal ran about ten times, and is injected from SMBIOS.
System Parameters has Inject System ID checked and Custom UUID field is left blank.
Questions I'm looking for answers:
Do I need to emulate NVRAM if Clover is injecting SMBIOS?
Is EmuVariableUefi-64.efi necessary on legacy clover build?
Is it better to inject MLB from SMBIOS or Rt Variables?
Clover config generated a serial that starts with D2 instead of C0 like before. Is that an issue?
I've read through the fix iMessage thread, but I wasn't able to find all the information I'd like to know.Is EmuVariableUefi-64.efi necessary on legacy clover build?
Is it better to inject MLB from SMBIOS or Rt Variables?
Clover config generated a serial that starts with D2 instead of C0 like before. Is that an issue?