- Joined
- Dec 24, 2013
- Messages
- 22
- Motherboard
- 10.10.2
- CPU
- i7 4770
- Graphics
- Intel HD4600
- Mac
- Classic Mac
- Mobile Phone
Hi Guys.
Have a fully working Clover install.
One thing. The 4600 works perfectly, except prior to the drive selection of clover at boot, my screen says no signal. it does this until i manually turn off the monitor, and back on. Anyway to stop this?
its a little thing, but quite annoying since my monitor is de-bezeled and the buttons are tucked away in the back.
Thank you so much
Have a fully working Clover install.
One thing. The 4600 works perfectly, except prior to the drive selection of clover at boot, my screen says no signal. it does this until i manually turn off the monitor, and back on. Anyway to stop this?
its a little thing, but quite annoying since my monitor is de-bezeled and the buttons are tucked away in the back.
Thank you so much