Installation freezes right after Apple logo

[skeet777]

I created an USB and started with installation, it stoped right after Apple logo, so I set the flag to -v -x and got this. Attached pic!

Running: i3 6100, DDR3 1600MHz Kingston, B150M-DS3H MOBO

 

[justynjj]

I created an USB and started with installation, it stoped right after Apple logo, so I set the flag to -v -x and got this. Attached pic!

Running: i3 6100, DDR3 1600MHz Kingston, B150M-DS3H MOBO

It's an issue with your USB setup. To fix this, you need to turn on USB Ownership in the Clover PCI Devices Options. To get to this in Clover:

Tap through the Clover options with right arrow key until you get to "Options" (NOT Clover Boot Options), press enter. Now select "PCI devices", then turn on USB Ownership by pressing enter on this.

All being good, you should be able to get past that error now.

You'll need to do this every time if booting from the USB device.

 

[skeet777]

THANKS! just finished installation and running multibeast

 

[Burkhalter123]

Thanks to you both, this was my issue on Gigabyte GA-Z170X-UD5-TH