Contribute
Register

Input not supported when booting with El Captain USB

Status
Not open for further replies.
Joined
Aug 10, 2016
Messages
1
Hello, I am trying to build my first hackintosh, but got stuck at the very first. I created bootable USB using uniBeast on VMware El Captain. When I boot with that USB, monitor shows "Input Not Supported". The same USB boots on my laptop. Below are my computer specs

Motherboard: Asus B85M-G
CPU: Core i5 4570
Ram: 16 GB DDR 3
Monitor: 2x 15.6 inch (1360x768 resolution connected with VGA)
Graphic card: ATI graphics card used only for secondary monitor
Input devices: USB keyboard and mouse
Hard disk: Samsune Evo 850 256 GB + 2 more HDD

I am not sure whats causing the issue. It it because of monitor using VGA ?

Thank you
 
I believe the installation instructions say that OSX does not support VGA and that the USB boot stick should not be made through VM.
 
Status
Not open for further replies.
Back
Top