So the card will be delivered any moment. I had a look at the flashing and SSDT procedure, but lots of links in the mini-guide are dead. This makes understanding what has to be done rather difficult.
I’ve updated a number of links. Please try again and point out any that might still be stale.
If you have a Raspberry Pi or Arduino kit, the kit might have a female to female jumper wire. That can be used to connect the top and middle pins. Without connecting the pins, the card will not turn on.
I only have 4-pin Groveconnectors for a Beagle board. Oh well.
www.tonymacx86.com
Links updated.[SUCCESS] Gigabyte Designare Z390 (Thunderbolt 3) + i7-9700K + AMD RX 580
*** Thunderbolt DROM Micro-Guide for Gigabyte GC-Titan Ridge V1.0 *** Please do not quote this micro-guide in its entirety. Post a link instead. Target Audience for this Procedure: Gigabyte GC-Titan Ridge V1.0 owners with activated Thunderbolt Bus. To activate Thunderbolt Bus, it's...
Procedure to flash Winbond chip: link is dead
PCI power is not necessary; it becomes necessary if we want to charge devices connected to the Thunderbolt ports.
Correct. The card should be removed from the computer when flashing. The SOIC clip should be attached and detached very gently. We don’t want to dislodge tiny nearby surface mount devices.
