I need help. My ethernet does not work (Gigabyte Aorus Z370 Gaming 5)

[Asiernineu]

Hi friends. I do a Mac High sierra installation in my computer, my setup:

Gigabyte Aorus Z370 Gaming 5
Intel Core i7 8700k
SSD Crucial MSX500 SSD
Seagate barracuda HDD
Gigabyte geforce 1080 8gb
16 gb ram Crucial ballistix

I have had problems configuring the BIOS. In the end I got a guide and I configured it in the following way:
BIOS Settings

1. Save & Exit → Load Optimized Defaults
2. M.I.T. → Advanced Memory Settings Extreme Memory Profile(X.M.P.) : Profile1
3. BIOS → Fast Boot : Disabled
4. BIOS → LAN PXE Boot Option ROM : Disabled
5. BIOS → Storage Boot Option Control : UEFI
6. Peripherals → Trusted Computing → Security Device Support : Disable
7. Peripherals → Network Stack Configuration → Network Stack : Disabled
8. Peripherals → USB Configuration → Legacy USB Support : Auto
9. Peripherals → USB Configuration → XHCI Hand-off : Enabled
10. Chipset → Vt-d : Disabled
11. Chipset → Wake on LAN Enable : Disabled
12. Chipset → IOAPIC 24-119 Entries : Enabled

Based on the GPU you’re using change the following settings:

Dedicated graphics card:

1. Peripherals → Initial Display Output : PCIe 1 Slot
2. Chipset → Integrated Graphics : Disabled

The installation run OK. I think that internet runs during the instalation, and after multibeast crash. In multibest i Do this:

1. Quick Start: UEFI Boot mode
2. Drivers-->Disk -->3rd PArty Sata
3. Drivers-->Disk -->3rd PArty eSata
   
4. Drivers --> Misc -->FAkeSMC
5. Drivers --> Misc -->FakeSMC Plugins
   
6. Drivers --> Misc -->FakeSMC HWMonitor Application
   
7. Drivers --> Misc -->NullCPUPPowerManagement
   
8. Drivers --> Network --> Intel --> IntelMausiEthernet v2.4.0
9. Drivers --> USB --> Remove XHCI USB Port Limit
   
10. Drivers --> USB --> USBInjectAll
    
11. Bootloaders --> Clover UEFI Boot Mode + Emultaed NVRAM
12. Customize --> System definitions -->IMac --> IMac 18,3
13. Ciustomize --> Grapichs --> Nvidia graphics fixup

Now my ethernet don´t run. How can I solve it? Thanks for your time friends.

 

[jpl4907]

Hi, how did you solve the ethernet problem? I have the same board, it was working and now it's dead. The network chipset...

 

[frikkieza]

Hi. Did you get it working? I have same issue. In control panel it says "Device cant start" Tried all drivers i could find but still not working