As anyone running the BCM94352Z wifi card on the S340 ?
Will it run 100% ?
Thanks
Hi to all. Is HDMI Working?
Same situation here, my trackpad is not working. i have no luck in deleting the kexts that were crossed out either.
I copied the folders from the REPO directly so if I'm not mistaken, they should be loaded. Opening the config in Clover Configurator shows the patches same as @lknparktheory88 screenshots so I think they are correct. I grabbed the latest VoodooI2C (2.3 if I'm not mistaken). I've put them in /L/E and re-ran the kextrepair after remounting the drive RW `sudo mount -uw /`.Double-check these items...
1) Install latest VoodooI2C.kext and VoodooI2CHID.kext
2) Add SSDT-GPI0 and SSDT-XOSI hotpatches to Clover/ACPI/patched
3) Make sure change _OSI to XOSI patch is enabled in your config.plist
I hope this helps.