Thanks, I'll check it again now. I don't have an SSD so didn't think I'd need apfs driver.
Have not upgraded to 10.14.5 yet. But have found an interesting workaround to get audio working again.
After booting up, if I plug in a headphone cable from the NUC to the monitor and then restart the monitor - the DisplayPort audio starts working again. I've tried other variations but it seems like I have to plug it in after logging in.
I have created a clover usb drive UEFI with 2 partitions mac os extended journaled with mojave in it EFI fat32 which has all kexts etc to get it going.
This drive wont boot up in my NUC with bios defaults and the few options changed in the instruction guide.
The USB drive will show up and run on my macair so I believe the usb drive is setup correctly.
Any ideas on were I should be looking?
Thanks
I see UEFI : USB : Mac OS X : PART 0 : OS Bootloader When I turn on the nuc and hit the F10 to select the boot option and when I select it nothing happens
Believe or not that working for me! Thanks so much! I think one kext doesn't load properly and that cause the loop at the configuration screen. So, now, I need fix the Audio because doesn't workTry to start the system in Safe Boot mode and see if the problem persists.
Hi have you managed to resolve the kext stalled ACPICPU problem? Mine is also i3syh, and has the same problem.
could u reply ur efi,thanksHello,
I have two Hackintosh's installed according this guide (which worked out perfectly THX @ Rehabman)
1. NUC6i7KYK running 10.14.3 (Clover 4701)
2. NUC6i5SYH running 10.14.3 and Window 7 (Clover 4658)
Both are running smooth.
The NUC6i5SYH mentioned the SW upgrade to 10.14.4 (and CL-tools).
But my NUC6i7KYK does not recognise that there is a SW upgrade available.
I haven't done the upgrade yet.
Did somebody with a NUC6 see similar things?
View attachment 395696View attachment 395697View attachment 395698