Leesureone
Moderator
- Joined
- Feb 21, 2010
- Messages
- 3,882
- Motherboard
- Asus Z790 Maximus Hero
- CPU
- i9-13900K
- Graphics
- RX 6950 XT
- Mac
- Mobile Phone
If the Clover menu is showing you are still booting from the hardrive so change the bios to boot from the USB drive first or hit the appropriate “F“ key too be able to access the boot menu. I think it’s F10 but I forget, it prompts you at boot anyway as too the correct key.I was hoping someone might be able to shed some light on an issue I'm having. I previously used this guide to build a Mojave NUC8i7BEH. Worked fine. I tried to make a clean install to Catalina and I got it to work, but only booting from the USB and in safe mode. Not good.
So I tried the open core method. But I'm super confused because I reformatted the USB and made it again using the OPEN core method. Then I dumped Leesureone's OpenCore efi from page 90.
When I go to install I'm still seeing the clover menu (I did copy a clover EFI to the internal HD's EFI partition). Is this right? Do I need to change my PCs boot priorities to USB first?
In any case after I run it in verbose I get this line and it hangs:
PCI configuration end, bridges 7, devices 14 ]
If anyone knows what I might be doing wrong I would appreciate it. Is there more patching that I have to do? Previously I just drag and dropped the EFI folder with Mojave and it worked, but maybe I'm missing a step with patches or something?