Leesureone
Moderator
- Joined
- Feb 21, 2010
- Messages
- 3,882
- Motherboard
- Asus Z790 Maximus Hero
- CPU
- i9-13900K
- Graphics
- RX 6950 XT
- Mac
- Mobile Phone
OK folks, let me preface this by saying I'm an idiot. I must be because I have followed the instructions now to a T but I am still missing something (no ethernet).
What am I missing. It feels like something small and obvious but I am pulling out what little hair I have left trying to figure this out.
- I installed Clover on my new hard drive and then went into the EFI-Backups folder and cleared out anything other than the r4961 folder because that is the latest build of Clover that I have installed (there were some lingering fragments of previous install versions from multibeast etc...)
- I then went into that and found the EFI folder and emptied it into the trash and then purged the trash
- I copied the contents of @Leesureone EFI folder from post 430 into the EFI folder
- I rebooted - No ethernet
- I repeated the above steps but copied the EFI folder from my original install USB (which had ethernet working!) - no ethernet.
Depending on what continent you live in you may need to apply the "Fix Regions" patch in the config.plist. You can do that through Clover Configurator