Hello! After reading your guide, was inspired to purchase a Optiplex 9010 MT, i7-3770 w latest BIOS. I've done builds before, not my first rodeo. Setup Unibeast (9.2.0), with latest Mojave 10.14.6 (freshly downloaded Dec 10, 2019) as described with all the kexts, config.plist copied as instructed. 24 GB of ram (came with 2 x 4GB, I added 2 x 8GB). Passed MemTest no problems. Samsung 860 EVO 500GB fresh formatted GUID and HFS+ as internal. BIOS settings as instructed. EVGA GTX 650 mini card, Kepler GPU. I've used this card in previous builds (El Cap and HSierra, and not had issues; there should be OOTB support for this card/Kepler in Mojave, is my understanding. HDMI connection to monitor. Primary display in BIOS set to Nvidia, not HD4000. No other cards installed other than the GTX 650. No other SSDs connected other than the Samsung on SATA 0, even DVD is disconnected, and SATA channels disabled in BIOS other than SATA 0. Followed instructions to the letter.
Boot from Unibeast USB, Clover 4920, select verbose mode, then "Boot macOS with selected options". Only other option I see selected is 'dart=0'. The verbose output shows macOS base system mounted and internal Samsung mounted, and NVidiaRAM driver. Right after that, system reboots, Clover reloads, showing only the USB key as bootable volume. Never reaches macOS installer initial screen. I can continue this and it simply reboots at same point, back into Clover, with only USB key as bootable volume. I believe overall system hardware is okay, I installed Windows 10 1909 and everything functioning (on a
DIFFERENT SSD, which is
NOT connected during this process, only the blank Samsung that I wish to install macOS on; I'm just mentioning that Windows 10 installed fine as an indicator that it doesn't appear to be a hardware problem per se). Have also tried "Boot macOS with injected kexts" in Clover, same result. Also tried two different USB flash drives, as well as an SSD in an external USB enclosure (with Unibeast installed to <32GB partition)
Attached is screen shot of last output just before it reboots.
Ideas? I don't have a DP cable or monitor with DP input, would have to order a DP to HDMI adapter, and try install using HD 4000 if you think issue may be the GTX 650 card?