jaymonkey
Moderator
- Joined
- Aug 27, 2011
- Messages
- 4,078
- Motherboard
- GB Z490 Vision D
- CPU
- i9-10850K OC @ 5.2 GHz
- Graphics
- RX6800-XT+UHD630
- Mac
- Mobile Phone
In Hackintool it seems to be labelled correctly as GFX0, but when I try to run "./gfxutil -f GFX0" I get "error: unsupported registry entry class type 'IORegistryEntry'."
@bendelaurence,
If Hackintool is reporting the device as GFX0 then you should be fine, the version of gfxutil attached to the guide is old and can be a bit finicky on some systems, @headkaze gave it a big overhaul some time ago .. try this version
Releases · acidanthera/gfxutil
Device Properties conversion tool. Contribute to acidanthera/gfxutil development by creating an account on GitHub.
github.com
No need to pass it any parameters, it should find all devices and list the names and pci paths.
I also seem to be suffering from this 'Mojave can't preview jpg problem' which is apparently solved by whatevergreen
That sounds like you don't have IQS working (Intel Quick Sync).
IGPU should be enabled in the BIOS and the Vega 64 configured as the Primary, then configure the IGPU as "Headless"
See the Section 4.2 of this guide for more info, or read the whole guide if your new to Lilu and its plug-ins :-
An iDiot's Guide To Lilu and its Plug-ins
An iDiot's Guide To Lilu and its Plug-in's Last Update: 22nd Jan 2021 (Add note about OpenCore config.plist modifications) About this Guide Note: This guide was written when Clover was the boot loader of choice as such the config.plist examples in this guide are mostley Clover specific ... if...
www.tonymacx86.com
Cheers
Jay