Contribute
Register

[Guide] HP ProBook/EliteBook/Zbook using Clover UEFI hotpatch

Status
Not open for further replies.
@Feartech Yo I’m starting over from scratch. It stopped booting for some reason. So I’m about to install 10.14.4. I’m going to wipe the drive right now. Actually doing it right now. I’m going around in circles again on where to start. I still have my USB installer setup from last time and I put multibeast Mojave on the flash drive and EFI mounter cuz I know I need that stuff.
 
@Feartech Yo I’m starting over from scratch. It stopped booting for some reason. So I’m about to install 10.14.4. I’m going to wipe the drive right now. Actually doing it right now. I’m going around in circles again on where to start. I still have my USB installer setup from last time and I put multibeast Mojave on the flash drive and EFI mounter cuz I know I need that stuff.
the guide doesn't use multibeast so no, you don't need that

please read the faq for proper hardware profile setup:
 
hd3000 not supported on Mojave, go back to High Sierra

Not officially supported, but it does work using dosdude1's macOS Mojave patcher.
 

Attachments

  • Screen Shot 2019-05-18 at 7.08.53 PM.jpg
    Screen Shot 2019-05-18 at 7.08.53 PM.jpg
    18.1 KB · Views: 71
I got freezes in macOS and a bit video artefacts. See th screenshot above.
 
please use site attachments next time

please read the faq for proper hardware profile setup:

Use this tool and upload your problem reporting files:
 
Here is debug, I forgot to mention i got full HD monitor connected via HDMI, there were no problems in EL Capitan.
 

Attachments

  • debug_7325.zip
    4.5 MB · Views: 61
Last edited:
Status
Not open for further replies.
Back
Top