Contribute
Register

[Guide] HP Envy Haswell series J/K/Q/N using Clover UEFI

Status
Not open for further replies.
This guide recommends the RehabMan version of Clover (current RehabMan build is r4444).
I followed the guide again and it keeps crashing before it can boot. ACPI stuff.
 
I followed the guide again and it keeps crashing before it can boot. ACPI stuff.
Could it be that I'm running it off a flash drive?
 
I followed the guide again and it keeps crashing before it can boot. ACPI stuff.

No "Problem Reporting" files attached.
Read FAQ, "Problem Reporting" again. Carefully. Attach all requested files/output.
https://www.tonymacx86.com/threads/faq-read-first-laptop-frequent-questions.164990/

Could it be that I'm running it off a flash drive?

Running what off USB?
As per guide, after installation, USB is not involved... system and Clover are installed to HDD or SSD connected via SATA.
 
No "Problem Reporting" files attached.
Read FAQ, "Problem Reporting" again. Carefully. Attach all requested files/output.
https://www.tonymacx86.com/threads/faq-read-first-laptop-frequent-questions.164990/



Running what off USB?
As per guide, after installation, USB is not involved... system and Clover are installed to HDD or SSD connected via SATA.

Well I installed your version of Clover to a usb because I can't boot from my ssd. I'll attach the files from Clover when I press f2 and f4.
 
Here's my clover directory.
 

Attachments

  • CLOVER.zip
    3.8 MB · Views: 117
Well I installed your version of Clover to a usb

Probably you're ACPI/config.plist is completely wrong on that USB.

because I can't boot from my ssd.

You should install the recommended Clover to the SSD as per post #1.

Here's my clover directory.

This configuration is completely wrong.
You have "final" config.plist but without correct content in ACPI/patched.
Guaranteed to fail.
 
Probably you're ACPI/config.plist is completely wrong on that USB.



You should install the recommended Clover to the SSD as per post #1.



This configuration is completely wrong.
You have "final" config.plist but without correct content in ACPI/patched.
Guaranteed to fail.

I'm not sure what I did, but now it works! Thanks for the help.
 
And just wondering, there isn't a way to get RTL8188EE working is there? If not I'll buy the BCM94352HMB.

EDIT: Nevermind, I work at a computer repair shop and pulled an AR9280 card out of a broken laptop. Works oob. :)
 
Last edited:

Attachments

  • debug_5118.zip
    2.3 MB · Views: 96
  • AppleHDA_IDT76e0_Envy.kext.zip
    8.5 KB · Views: 152
Status
Not open for further replies.
Back
Top