@Sniki or anyone who can help:
I have an 8300 USDT with i3 3425 processor and 16Gb RAM and this works fine with Catalina via Clover.
Using the sniki BigSur Github guide and files of yesterday and the videos on YouTube (part1 and part2) I made an install USB. All well and good but it doesn't show anything on screen when booted up (the USB). I know that it was created ok and works to boot as I booted it on my Dell 7010 SFF which has an i7 3770 in (same as sniki processor used in the EFI).
So I am wondering if the config.plist needs to be adjusted for the 3245 and what adjustments are needed or whether it could be something else. It's just a blank screen on booting. My bios is 2.99 and the bios settings are as per the videos.
Thanks.