Does it work with the ssd attached below?
It is a comment to me because of the comment link, but this post is for you.Not my first time trying to install Mojave on my HP8300 with I7-3770 but first time with this guide and it was successful, thank you so much!
Only issue I ran into was with the Power Management section, "Custom SSDT.aml using ssdtPRGen.sh" When I installed the custom SSDT.aml, the system would not boot, the progress bar under the apple just completed and then got stuck there. When I don't use the custom SSDT.aml, everything seems to work.
I didn't see a way to do it using Clover Configurator to adjust the config.plist
Tim and Asural,
Thanks for supplying these SSDT files. Each can be opened with MaciASL and
saved as a DSL file, and you can use the terminal diff command to show the
differences between the text-based DSL files.
Like me, Asural is using a more recent version of SSDTPRgen.sh, version 17.0.
If you go to
Releases · Piker-Alpha/ssdtPRGen.sh
Script to generate a SSDT for Power Management. Contribute to Piker-Alpha/ssdtPRGen.sh development by creating an account on GitHub.github.com
you'll see that version 17.0 is the most recent release version, and I find it more
reliable. Tim, you're using an older version 15.6.
In addition, there's a difference in an address on line 521 between the two files
and two addresses on lines 527-528.
Finally, Asural's file is set up for "machdep.xcpm.mode....: 1" whereas Tim's
is set up for "machdep.xcpm.mode....: 0."
Tim, I would regenerate your file using version 17.0, and make sure you are
using the correct xcpm settings. I don't use Clover anymore, but I think your
relevant settings depend on whether you have "Generate" and/or "Plugintype"
set on your Clover Configurator "ACPI" page, and whether you have "KernelXCPM"
set on your Clover Configurator "Kernel and Kext Patches" page.
Could you delete your serial number from your config.plist, zip it up and post it?
Thanks for helping us to sort this out for other users.
Ok thanks both.
I had just been using the terminal command in the beginning of this guide: "curl -o ./ssdtPRGen.sh https://raw.githubusercontent.com/Piker-Alpha/ssdtPRGen.sh/master/ssdtPRGen.sh"
didn't realize that needed to be updated or pointed to a new version.
The file created by starting Clover r5119 is different from the file created by starting Open Core 0.5.9, so I attach it for reference.Tim and Asural,
cd ~/PRGen170
rm -r ~/Library/ssdtPRGen
~/PRGen170/ssdtPRGen.sh -p i5-3570
cp ~/Library/ssdtPRGen/SSDT.aml ~/PRGen170/SSDT-PM.aml
cp ~/Library/ssdtPRGen/ssdt.dsl ~/PRGen170/SSDT-PM.dsl
The file created by starting Clover r5119 is different from the file created by starting Open Core 0.5.9, so I attach it for reference.
The created command is as follows.
Code:cd ~/PRGen170 rm -r ~/Library/ssdtPRGen ~/PRGen170/ssdtPRGen.sh -p i5-3570 cp ~/Library/ssdtPRGen/SSDT.aml ~/PRGen170/SSDT-PM.aml cp ~/Library/ssdtPRGen/ssdt.dsl ~/PRGen170/SSDT-PM.dsl