[GUIDE] Full Power Management w/ Dual/Single Broadwell-EP/Haswell-EP CPUs on 10.12.

[dude05]

Thanks for the guide. Just what I have been looking for. But I am a bit lost abt the ssdt part. I got dual 2687W v3 10core each on X10Dai. Do I try to generate the ssdt from my X10Dai once i get it booting into the installer with terminal?? or can i generate it from my old macbookpro with yosemite??
I have a few other hacks running but never for once had to use ssdt before.

thanks

 

[dr01dy]

great guide. This is allowing me to get into the install and get all the way through it. After post install I keep getting a reboot loop . I'm getting an error message com.apple.xpc launchd userspace teardown took. Anyone come across this? I'm so close!

 

[dr01dy]

I was able to get it going, I had to just reinstall again. I'm trying to follow along with the rest of the guide. I don't think my CPU is setup correctly.


I thought I had it, installed 10.12.1 and now if failing to boot. It's yelling about CPUPowermanagement and Fault CRC CPU.

 

[robinqu]

After I applied the following patches, clover won't pass the first screen.

20B9E20000000F30 20B9E20000009090 xcpm_idle patch by Pike R. Alpha 10.12
83C3C483FB22 83C3BC83FB22 xcpm_bootstrap Sierra © Pike R. Alpha 10.12
BE0200000031D2E86CFCFFFF BE0200000031D29090909090 xcpm_core_scope_msrs © Pike R. Alpha 10.12
BE0700000031D2E894FCFFFF BE0700000031D29090909090 xcpm_pkg_scope_msr © Pike R. Alpha 10.12
83C0E9 83C0E1 Broadwell-E CPUID Patch 10.12




I haven't run ssdtPRGen.sh yet.

Should I generate the ssdt first before applying those patches?

 

[dr01dy]

Here are my results I can't get Intel Power Gadget to install. I get the following error message

 

[dr01dy]

After I applied the following patches, clover won't pass the first screen.

Which motherboard are you using?

 

[dr01dy]

How do I generate a SSDT and do I need to because I don't care about PowerManagement. I have a MacPro, 6.1 with a Intel Broadwell-E Core i7-6900K. I have the script I just don't know the switches to use..

 

[dr01dy]

See attached -

 

[nmano]

10.12.1 XCPM with C3
XMP: profile 1
C1E: Disabled
C6/C7: Enable
CPU Thermal Monitor: Enabled
C3: Enable
EIST: Disable

 

[robinqu]

That's it.