Did you try to update to the latest clover? That solved my problem during update to 10.14.4.Hi.
I Have the same Problem with update to 10.14.4.
Boot stucks @ (Attached Picture)
For 10.14.4 you need clover 4910 and to update lilu, whatevergreen, and applealc:Anyone get 10.14.4 updated on the 7559 successfully? I have had nothing but issues.
Using a clone of my SSD, running Clover 4862, update crashes on first boot when initially starting update.
Updated Clover to 4895, and could no longer even boot.
Restored Clover to 4862 in order to regain boot.
Updated Lilu, Whatevergreen, AppleALC, and USBInjectAll to latest, and could not boot.
Restored same kexts using backups of them, cleared kextcache, and restored EFI folder from backup, but only black screen at boot. Turns out system is booting, but internal screen is black, while HDMI connected monitor works fine.
Tried to put everything back as it was, but could never get the internal screen to work. Wound up putting my original SSD back, and system boots fine.
I would be interested in hearing what the secret is to get this update installed and booting.
For 10.14.4 you need clover 4910 and to update lilu, whatevergreen, and applealc:
Clover 4910
lilu v1.3.5
AppleALC v1.3.6
WhateverGreen v1.2.7
For 10.14.4 you need clover 4910 and to update lilu, whatevergreen, and applealc:
Clover 4910
lilu v1.3.5
AppleALC v1.3.6
WhateverGreen v1.2.7
Thats it. That solved my problem and 10.14.4 is running
Thank You
EFI/CLOVER/kexts/OtherIf you read my post before yours, I cannot get my 7559 to boot after updating Lilu/WG/AppleALC to those versions.
Can you detail the method you used to update those kexts? Are they on your EFI volume in CLOVER or in your L/E folder?
Am I doing it differently than you?
Thanks.
If you read my post before yours, I cannot get my 7559 to boot after updating Lilu/WG/AppleALC to those versions.
Can you detail the method you used to update those kexts? Are they on your EFI volume in CLOVER or in your L/E folder?
Am I doing it differently than you?
Thanks.
Thanks I will try. BUT, I am confused because everything I've read (especially from some highly regarded people here) says to ALWAYS install kexts in L/E except for FakeSMC. Now you say those three kexts should be in my EFI folder.The Files must be in EFI/CLOVER/kexts/Other. I made a Zip file of my Other folder. You can replace it with your folder.
For fresh install put the files on USB STICK in EFI/CLOVER/kexts/Other. I tested it successfully too.
Good Luck