RehabMan
Moderator
- Joined
- May 2, 2012
- Messages
- 181,111
- Motherboard
- Intel DH67BL
- CPU
- i7-2600K
- Graphics
- HD 3000
- Mac
- Mobile Phone
Sorry about that.
No worries. Just trying to keep this thread focused on the procedures as described in post #1.
Sorry about that.
I am sure this is covered but... If there are only two USB2 ports (HS13 + HS14), is there a reason to have USB3 ports set as HSxx (HS03-HS08) in the SSDT? I hope I am asking the question clearly. Can the ports designated as HS03-HS08 be deleted from the SSDT?No worries. Just trying to keep this thread focused on the procedures as described in post #1.
I am sure this is covered but... If there are only two USB2 ports (HS13 + HS14), is there a reason to have USB3 ports set as HSxx (HS03-HS08) in the SSDT?
Do you see any problems with what I have uploaded?You will need the HSxx associated with your USB3 ports for the case you plug a USB2 device into one of those ports. If you delete the HSxx ports associated with USB3 ports, USB2 devices plugged into those ports will not work. You should have 1x HSxx port marked UsbConnector=3 for each SSxx port that is marked UsbConnector=3.
Do you see any problems with what I have uploaded?
Did not forget. I removed it due to the cascading problems all of which began when I installed the SSDT-UIAC.aml in ACPI/patched. At first all was smooth, then sleep problems, then read/write speeds plummeted, then USB 3 devices would either not install on the desktop or if they did then they could not be ejected at which point I removed the SSDT-UIAC.aml in ACPI/patched and reinstalled port limit patch for 10.14.1. Sleep is back to normal, USB 3 devices appear to work normally so I am not sure what the problem was with the SSDT-UIAC.aml I created. Plus, IOReg is not showing SS ports at all, where they were before the SSDT was installed. Any ideas or solutions would be appreciated. Thank you.Obvious problem:
You forgot to put SSDT-UIAC.aml in ACPI/patched.
Did not forget. I removed it due to the cascading problems all of which began when I installed the SSDT-UIAC.aml in ACPI/patched. At first all was smooth, then sleep problems, then read/write speeds plummeted, then USB 3 devices would either not install on the desktop or if they did then they could not be ejected at which point I removed the SSDT-UIAC.aml in ACPI/patched and reinstalled port limit patch for 10.14.1. Sleep is back to normal, USB 3 devices appear to work normally so I am not sure what the problem was with the SSDT-UIAC.aml I created. Plus, IOReg is not showing SS ports at all, where they were before the SSDT was installed. Any ideas or solutions would be appreciated. Thank you.
Next, we boot with -uia_exclude_hs uia_include=HS03 to test SSxx and USRx ports.
I have placed the SSDT back in ACPI/patched. Attached is the zipped dumped problem reporting files.Problem reporting files must represent the problem scenario. No exceptions.