- Joined
- Jan 17, 2011
- Messages
- 14
- Motherboard
- GIGABYTE GA-Z68X-UD3-B3
- CPU
- Core i5 2500k
- Graphics
- nVidia GTX 570
- Mac
- Classic Mac
- Mobile Phone
So, this is not my first Hackintosh build, but I'm having a problem right out of the gate that I can't seem to get by.
When I go to run Unibeast and install from my usb drive, everything boots fine. However, when I select USB to do the install, it goes to the white(ish) apple loading screen and then the screen goes blank like the graphics card stopped getting a signal. I've read about others that have had this problem, but I've been unable to fix it.
I tried lots of different options, with the only one that gave me any "progress" being:
GraphicsEnabler=yes PCIRootUID=1 -x
The only thing that gave me differently was it got past the blank screen and went to an all white(ish) screen. Then stuck on that screen.
When I run verbose with -v it was stopped where the image I attached shows.
Any thoughts?
When I go to run Unibeast and install from my usb drive, everything boots fine. However, when I select USB to do the install, it goes to the white(ish) apple loading screen and then the screen goes blank like the graphics card stopped getting a signal. I've read about others that have had this problem, but I've been unable to fix it.
I tried lots of different options, with the only one that gave me any "progress" being:
GraphicsEnabler=yes PCIRootUID=1 -x
The only thing that gave me differently was it got past the blank screen and went to an all white(ish) screen. Then stuck on that screen.
When I run verbose with -v it was stopped where the image I attached shows.
Any thoughts?
