Gigabyte Z690 Aero G + i5-12600K + AMD RX 6800 XT

[CaseySJ]

Sorry, which post again?

Oops, this one:

Thunderbolt 4 modified firmware with Full Thunderbolt Local Node

Thanks for the input! OK, so I have to get a CH341A programmer. I was researching in other forums to see if someone with the same motherboard had done it previously, but I guess I would be the first! Motherboards can be tricky to work with. It may be best to remove/disconnect all devices before...

www.tonymacx86.com

 

[beelzebozo]

Oops, this one:

Thunderbolt 4 modified firmware with Full Thunderbolt Local Node

Thanks for the input! OK, so I have to get a CH341A programmer. I was researching in other forums to see if someone with the same motherboard had done it previously, but I guess I would be the first! Motherboards can be tricky to work with. It may be best to remove/disconnect all devices before...

www.tonymacx86.com

Thanks for that.

This is what I've implemented-

Renamed device from RP05 to RP09 based on IOREG.

No hot-plug, only cold boot works.

 

[CaseySJ]

Thanks for that.

This is what I've implemented-

Renamed device from RP05 to RP09 based on IOREG.


No hot-plug, only cold boot works.

This is the same behavior I observed on my Gigabyte Z390 Designare. Flashing the firmware enabled Thunderbolt Local Node, but broke sleep. It may be possible to bypass the sleep problem by using the GPRW SSDT and ACPI patch. I’ll get back to this soon.

 

[oldthree]

Will refer to
gigabyte z790m 12600kf rx580