Successfully deployed my first Hackintosh thanks to this build!
Gigabyte Z490 Vision G
Intel i5 10400
Gigabyte Radeon RX580 8Gb
Samsung 970 EVO Plus 1Tb M.2
32Gb Ram (Corsair Vengeance 2x 16GB RAM DDR4, 3200MHz)
Had trouble with my initial Clover install then stumbled on this (very similar) build so figured I'd try following the steps.
BOOM!!! I stuck to the steps verbatim and it installed and booted first time and took less than an hour! Brilliant write-up, step-by-step instructions and attached file sets! Thank you CaseySJ!
The ONLY 2 small changes to the step-by-step instructions I'd suggest are to do with the "Vision G" - specific part.
(1) Suggest a spoiler link for the "Vision G" peeps before end of
Step 4 (ie: during
OpenCore Configurator and before
Copy EFI folder to EFI partition).
(2) The name of the file in the G Package is “SSDT-UIAC-VISION-G-V2.aml” so I have used this file name in place for both the below steps:
- In the OpenCore ACPI folder, replace SSDT-UIAC-VISION-D-V2.aml with SSDT-UIAC-VISION-G-V1.aml located in the attached Vision G Package.zip
- Then open config.plist in OpenCore Configurator and change the rename SSDT-UIAC-VISION-D-V2.aml to SSDT-UIAC-VISION-G-V1.aml in the ACPI section.
Unfortunately I'm stuck with my wired USB kbd/mouse while my Magic Mouse & KBD await a working Bluetooth/Wireless solution - awaiting components. Wired Internet for now - works great!
G.