Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

[bazzevo]

I managed to update to 0.7.6, and it booted Catalina fine. AppleVTD enabled ok, bluetooth was working, but wifi was not. All worked fine under 0.6.8. Any ideas or similar issues?

Thanks.

 

[CaseySJ]

I managed to update to 0.7.6, and it booted Catalina fine. AppleVTD enabled ok, bluetooth was working, but wifi was not. All worked fine under 0.6.8. Any ideas or similar issues?

Thanks.

As an experiment, please try disabling AppleVTD by following the procedure described in link at the top of 0.7.6 mini-guide.

 

[suren6791]

@CaseySJ, I finally upgraded my Big Sur M.2 drive to Monterey and all went well but the boot time is very long. It sits on the attached screen for like a minute or less then completes the boot. Do you have any suggestions to try. I am using your 0.7.5 OC EFI.

 

[taconugget]

** OpenCore 0.7.6 EFI for Z490 Vision D and G **
Supports Catalina, Big Sur, and Monterey
Please do not quote this post in its entirely. Use a link instead.
​

Happy to report another successful upgrade to OC 0.7.6 on Monterey! Thanks @CaseySJ

 

[CaseySJ]

@CaseySJ, I finally upgraded my Big Sur M.2 drive to Monterey and all went well but the boot time is very long. It sits on the attached screen for like a minute or less then completes the boot. Do you have any suggestions to try. I am using your 0.7.5 OC EFI.
View attachment 536723

Please read the top part of OpenCore 0.7.5 or 0.7.6 mini-guides.

 

[kemmet]

I use your OpenCore ver 0.7.5 and it works perfectly on z490 vision G (bios F6).
I have to change the CPU Base Clock from Auto to 100MHz to make "sleep and wake" function to work properly.

There is an issue that the rear port audio is not working to get 7.1 sound audio.

 

[canyondust]

update: slept for 4 hours, wake from sleep was perfect and drives remained mounted. As NASA would say: All systems nominal.

Update: left it sleeping overnight. USB drives disconnected during sleep. This is unrelated to the BIOS update as it is something that I have been experiencing since around Big Sur 11.5 (not exactly sure when it started). Still trying to sus that one out.

 

[CaseySJ]

I use your OpenCore ver 0.7.5 and it works perfectly on z490 vision G (bios F6).
I have to change the CPU Base Clock from Auto to 100MHz to make "sleep and wake" function to work properly.

There is an issue that the rear port audio is not working to get 7.1 sound audio.

Hello @kemmet

Which version of macOS are you running?

Also, please post screenshot of the following:

 

[kemmet]

Hello @kemmet

Which version of macOS are you running?

Also, please post screenshot of the following:
View attachment 536755

I use Bigsur 11.6.1
Side, Front, C/Sub port audio work normally else Real port doesn't work.

 

[CaseySJ]

I use Bigsur 11.6.1
Side, Front, C/Sub port audio work normally else Real port doesn't work.

I've never used 7.1 output so I don't know whether it's supported. Did the rear port work before in macOS?

Which Layout ID are you using in NVRAM --> Boot-Args? You'll see a parameter called alcid. Have you tried different IDs?