Gigabyte Z490 Vision D (Thunderbolt 3) + i5-10400 + AMD RX 580

[starchyfind]

Hi,
Does anybody know of an external USB drive dock which works with this hackintosh?
I have an old Sabrent with a JMS561U chipset which works very erratically, e.g it mounts but then it dismount after a few second by itself. And the USB is not see anymore

This is the one I've been using for years without issue:

Vantec NexStar Dual Bay 2.5"/3.5" SATA to USB 2.0 & eSATA Hard Drive Dock - Model NST-D200SU - Newegg.com

Buy Vantec NexStar Dual Bay 2.5"/3.5" SATA to USB 2.0 & eSATA Hard Drive Dock - Model NST-D200SU with fast shipping and top-rated customer service. Once you know, you Newegg!

www.newegg.com

 

[Higgie]

Anyone any closer to figuring out why TB3 hotplug has stopped working on unflashed boards?

Still looking for an answer to this. Haven’t had much time to experiment but wondering if it could be anything to do with the DMAR and AppleVTD

 

[giertosan]

Hi! After upgrading my Z490 Vision D to Monterey, my ProTools is not able to see my HDX-card. Nor is the system able to see the core-audio driver. Catalina worked no issus..Anyone?

Opencore 0.7.4. Used the guide in the beginning of this thread.

 

[xiuer]

About i225-V
Tried: Launch AppleVTD, I225-Vmod.zip, but it didn't work until I used appleigc.kext i225-V works fine!

 

[giertosan]

When I update to oc 0.8.3 and used the settings in the guide, only USB-2 i working?
Any solution I´m on Monterey 12.6.5 My Machine is GA z490 Vision D

 

[CaseySJ]

When I update to oc 0.8.3 and used the settings in the guide, only USB-2 i working?
Any solution I´m on Monterey 12.6.5 My Machine is GA z490 Vision D

Please run Hackintool, select the USB tab, and post a screenshot of that page.

 

[giertosan]

Please run Hackintool, select the USB tab, and post a screenshot of that page.

Here it is!

 

[CaseySJ]

Here it is!

This indicates that the USB port map is not enabled or configured in config.plist. Let’s take a look at screenshots of these pages in OpenCore Configurator:

1. ACPI
2. Kernel

 

[giertosan]

This indicates that the USB port map is not enabled or configured in config.plist. Let’s take a look at screenshots of these pages in OpenCore Configurator:

1. ACPI
2. Kernel

 

[CaseySJ]

@giertosan

Please enable XhciPortLimit quirk in Kernel section and reboot. Then check USB 3 devices again.