<< Solved >> Gigabyte Z390 Catalina install stuck on logo

[G5Heaven]

I have Unibeast and Multibeast installed on my 16GB thumb drive. I can load Clover and hit install but it just hangs on installation. This is using a Gigabyte Z390 UD board. This is the TonyMacX86 CustoMac Coffee Lake 300 build. I am using the installation instructions from this site. Any ideas?

 

[G5Heaven]

In boot flags, I entered -v, -s, -x. This system uses onboard Intel HD Graphics. I got verbose mode to work but I am using my TV and the text is partially cut off on the side and bottom. I'm working on checking the output from the log. The hidden text is underneath the bezels on my TV! I'm going out to grab a monitor. I'll keep you updated.

 

[G5Heaven]

Here is the error section from verbose:

 

[G5Heaven]

I ended up ditching Unibeast and installing with OpenCore. I have Catalina running. There are just a few issues I need to work out post-install. Once that is complete, I will post a build guide on here.