- Joined
- Sep 8, 2012
- Messages
- 39
- Motherboard
- Gigabyte X299X Designare 10G
- CPU
- Intel i9-10900X
- Graphics
- Radeon VII
- Mac
- Mobile Phone
hey @dolgarrenan
Thank you for your answer!
Let me provide some more information: I never used clover on this system. I've got one USB stick with your EFI and one with a fresh OC 0.5.9.
I added the compiled RTC0 to ACPI and config.plist
I enabled Above4G Decoding in BIOS
I enabled IncreasePciBarSize in config.plist
I tested the unmodified SSDT-X299X-DESIGNARE10G-THUNDERBOLT-SIMPLIFIED.aml
I cleaned the NVRAM
But still the same error:
But I retried your EFI again and it boots. Unfortunately, my Radeon VII has a black screen or the system crashes as soon as the graphics should start :/
What else did you change to get Thunderbolt working?
EDIT:
I checked the logs with your EFI folder and that
EDIT2:
Do you have these annoying "BIOS crashes" while BIOS boot up or in OpenCore selection that leads to the "Boot Failure detected" -> "Load Optimized Defaults then boot", "Load Optimized Defaults then reboot" and "Enter BIOS"? Do you know how to solve this? Firmware is F3B with your settings.
Thank you for your answer!
Let me provide some more information: I never used clover on this system. I've got one USB stick with your EFI and one with a fresh OC 0.5.9.
I added the compiled RTC0 to ACPI and config.plist
I enabled Above4G Decoding in BIOS
I enabled IncreasePciBarSize in config.plist
I tested the unmodified SSDT-X299X-DESIGNARE10G-THUNDERBOLT-SIMPLIFIED.aml
I cleaned the NVRAM
But still the same error:
IOThunderboltEEPROM::getDROM - Error getting DROM from I/O Resistry (0xe00002be)
But I retried your EFI again and it boots. Unfortunately, my Radeon VII has a black screen or the system crashes as soon as the graphics should start :/
What else did you change to get Thunderbolt working?
EDIT:
I checked the logs with your EFI folder and that
IOThunderboltEEPROM::parseDROMData - Failed CRC8 Verification: 0xb != 0xd6
IOThunderboltEEPROM::getDROM - Error getting DROM from I/O Resistry (0xe0000001)
EDIT2:
Do you have these annoying "BIOS crashes" while BIOS boot up or in OpenCore selection that leads to the "Boot Failure detected" -> "Load Optimized Defaults then boot", "Load Optimized Defaults then reboot" and "Enter BIOS"? Do you know how to solve this? Firmware is F3B with your settings.
Last edited: