- Joined
- Jun 25, 2011
- Messages
- 48
- Motherboard
- GIGABYTE GA-Z170N-WIFI
- CPU
- Intel Core i7 - 6700k
- Graphics
- Radeon RX 580
- Mac
- Mobile Phone
Hey Guys,
And again I need your help. This time I updated to El Capitan using your awesome Software and Installation Guide. However this is my first time using clover and I'm facing a couple of problems.
The installation works without any problems and so does booting the system for the first time via the USB Installer.
Also my Dual-Monitor setup using HDMI and DVI works fine even though the graphics are shown as Intel HD 2000 and not 3000. --> Mac Mini 5,1
When I then install the CustoMac Essentials and Clover Bootloader to the EFI Partition and reboot and finally after 3-4 times get the system to boot only the Monitor which is connected via DVI works properly, the other one shows a very blurred synchronised image.
SMBIOS is set to MacPro 3,1 --> MacMini 5,1 causes kernel panic on boot.
Even tried Fake ID for Intel HD 3000 as it is used by UniBeast. No change.
Any ideas?
And again I need your help. This time I updated to El Capitan using your awesome Software and Installation Guide. However this is my first time using clover and I'm facing a couple of problems.
The installation works without any problems and so does booting the system for the first time via the USB Installer.
Also my Dual-Monitor setup using HDMI and DVI works fine even though the graphics are shown as Intel HD 2000 and not 3000. --> Mac Mini 5,1
When I then install the CustoMac Essentials and Clover Bootloader to the EFI Partition and reboot and finally after 3-4 times get the system to boot only the Monitor which is connected via DVI works properly, the other one shows a very blurred synchronised image.
SMBIOS is set to MacPro 3,1 --> MacMini 5,1 causes kernel panic on boot.
Even tried Fake ID for Intel HD 3000 as it is used by UniBeast. No change.
Any ideas?
