GA H97-D3H - Not able to boot USB successfully

[Mariappan]

My Setup:
GA H97-D3H
Core i5 4690
Kingston 8GB RAM
Kingston 120GB SSD

I created the installer using the Unibeast following the tutorial from
http://www.tonymacx86.com/el-capita...-el-capitan-any-supported-intel-based-pc.html

When i try to boot from the USB, booting stuck at the following place:


Sometimes I am getting extra line like
roooting via boot-


I tried booting in single user and safe mode also.
Removed one 4GB RAM and extra harddisk also.
No luck, Anyone facing this issue.

Any help would be greatly appreciated. Thanks

 

[Mariappan]

There does not seem to be any ASSERT

 

[plcv83]

quite the same problem for me
http://www.tonymacx86.com/el-capitan-desktop-support/174444-ga-z97-d3h-setup-clover-boot-fails.html

with GA E97 D3H / 16Go / 120Go SSD

if you find something........ share

 

[Mariappan]

Just checked your error status from your screenshot
It shows that it has crossed mine. For me it has not even started.

 

[ammulder]

Could be that the integrated graphics isn't starting up? Maybe make sure inject intel is set to true in config.plist? Maybe try putting an ig-device-id in there if not present already?

 

[Mariappan]

Thanks ammulder. I tried editing the clover config.plist.

Enable inject Intel
Enabled the flags one by one
* cpus=1
* arch=x86_64
* -gux_nosleep
Enable USB Inject
Added NullCpuPowerManagement kext also

No luck still. I have connected my monitor to the DVI port.
Anything else I am missing, any obvious thing. Or is there anything wrong in the logs.
​

 

[ammulder]

I see in your screen shot cannot assert wake from d3cold, and I see this post suggesting a BIOS change.