Freeze on Apple Logo after boot0 error fix

[RBrNx277]

Hi there, recently built a Hackintosh and followed the iBoot + Multibeast tutorial to install Snow Leopard. Once this was installed I realised I was getting the famous boot0 error when trying to boot from the Hard Drive. I followed this guide to fix the boot0 error, and it worked! Until I attempted to boot from the Hard Drive and found out that the Hackintosh will just get stuck at the grey apple logo and go no further.

Tried to boot with -x, -v, -f, GraphicsEnabler=No, and PCIRootUID=0 but all of these result in a very long list of commands being executed followed by a black screen. The black screen will stay there for about 2 minutes before the computer restarts itself. Is there any fix for this?

My specs:
Intel i5 4590
Crucial Ballistix 8GB
Corsair CS450M
Gigabyte H97-D3H Motherboard
No Graphic Card

 

[Going Bald]

Is there any fix for this?

My specs:
Intel i5 4590
Crucial Ballistix 8GB
Corsair CS450M
Gigabyte H97-D3H Motherboard
No Graphic Card

Yes, install Yosemite 10.10.5 or El Capitan 10.11.

Did you bother to read the first paragraph of the guide at http://www.tonymacx86.com/snow-leop...os-x-10-6-snow-leopard-haswell-based-pcs.html ? If you had, your answer would be obvious.

 

[RBrNx277]

Ahh thank you. I didn't actually see that post, only the iBoot + Multibeast guide which I followed. Thanks for the help.