Contribute
Register

First build: Z87X-UD5H, i7-4790K, GTX 770 4GB, Kernel Panic

Status
Not open for further replies.
Joined
Jul 3, 2014
Messages
2
Motherboard
Gigabyte GA-Z87X-UD5H
CPU
i7-4790K
Graphics
Gigabyte GeForce GTX 770 4GB
Mac
Classic Mac
Mobile Phone
Hello,

I'm all new to Hackintosh building and i would like some help.

My setup:
Gigabyte z87X-UD5H
Intel i7 4790K
Corsair 32GB (4x8GB) CL10 1600Mhz VENGEANCE (Currently running one 8GB modul)
Gigabyte GTX 770 (4GB) OC Rev 2
Samsung 840 SSD 256 GB

What iv'e done so far:
I followed the "Installation Guide" and also used this post to get BIOS and Multibeast help:
http://www.tonymacx86.com/user-buil...ud5h-i7-4770k-32gb-ddr-3-igfx.html#post722935

I have also disabled Vt-d and Intel Virtualization Technology in BIOS.

After installing without any problems i booted in to 10.9 with the -x flag and did the Multibeast install with the above mentioned settings. After a reboot i get a Kernel Panic with backtrace:
com.apple.driver.AppleACPIPlatform(2.0)(...)
dependency: com.apple.iokit.IOACPIFamily(1.4)
(...)
dependency: com.apple.iokit.IOPCIFamily(2.9)
(...)
I have attached an image of the complete Kernel Panic.
kernelpanic.jpg

Iv'e tried booting with different flags including: UseKernalCache=No, -x and -v ofc.

Any one got any good suggestions on what to try next?

Thanks!
 
Joined
Jul 8, 2014
Messages
1
Motherboard
GA-Z87X-UD 5H
CPU
i7-4790k
Graphics
GTX760
Mac
Classic Mac
Mobile Phone
Last night I encountered this exact issue after following that thread. I have the same components as you except I went with the GTX 760.

I was able to boot back into Mavericks by firstly going to my BIOS and resetting it to "optimized defaults". Then I was able to sign in via safe mode flag (-x) and run Multibeast. Rebooted after the Multibeast install completed and it booted back in Mavericks without having to use safe mode.

HTH

RJ
 
Joined
Sep 28, 2011
Messages
97
Motherboard
Z87X-UD5H
CPU
i7 4790K
Graphics
GTX 960 / GTX 1080
Mac
  1. Mac mini
Mobile Phone
  1. Other
Last night I encountered this exact issue after following that thread. I have the same components as you except I went with the GTX 760.

I was able to boot back into Mavericks by firstly going to my BIOS and resetting it to "optimized defaults". Then I was able to sign in via safe mode flag (-x) and run Multibeast. Rebooted after the Multibeast install completed and it booted back in Mavericks without having to use safe mode.

HTH

RJ

I have bought the same Board and CPU. Are you still working this hardware setup? Are you satisfied with this? Everything working fine? Audio, Lan, Cpu, Memories? Is it stable? USB3 working? Both front and rear?
Because I am afraid that I would have buy the Z97 chipset.
 
Status
Not open for further replies.
Top