- Joined
- Jan 25, 2017
- Messages
- 11
- Motherboard
- İntel
- CPU
- İntel HD GRAPHİC 4400
- Graphics
- Nvidia
- Mobile Phone
The microphone picks up my voice, but it takes very little, and there are hissing noises at the back. He's picking up the voices outside.
Realtek ALC233 LOW MİCROFONE
Hello!
So My hackintosh has been working beautifully for about 2 months now and this morning I went to go use it and I got this kernel panic. Im not sure what to do. I read the "Problem Reporting" section of this thread. I have attached a picture of the verbose text. I know it says to also add my EFI/Clover but I don't know how to get it since my computer won't boot.
Thanks in advance for the help! This community is great!
Also open a separate thread.
This is not a troubleshooting thread.
I've been trying to get macOS going for several days now by following the post at https://www.tonymacx86.com/threads/...k-touch-1tb-ssd-32gb-ram-100-adobergb.224486/ and I can't get through step 11... actually installing the OS. I'm trying to install from the most current download from the Apple Store. I don't see any obvious errors (except the occasional one below) and I have put in a valid serial number and changed the BoardSerialNumber and SmUUID according to https://clover-wiki.zetam.org/Configuration/SMBIOS information. I have created the installation media from 2 different macbook pros.
When I boot it just stops loading... usually at a different place every time. Occasionally I get an error about
"SuperIODevice: [Fatal] found unsupported chip! ITE sequence ID=0x1d00, Windbond sequence ID=0xFFFF"
Thanks for the help
tested.[/QUOTE said:Sleep through USB mouse after wake up, the keyboard can awaken. But U disk will be prompted to disconnect. Start the boot has obvious errors, but patchmatic was used to extract and dismantling compiler can pass. I'm not sure whether SSDTs have duplicate files. Unable to use the SSDT-Plugintype1. The aml complains. Isn't it should not take the SSDT-2.aml in CLOVER\ACPI\patched? Kextstat | grep-y appleintel CPU doesn't print the driver
USB_PRW_0x6d_xhc for use in a patch to a value of 2100, 1600, 2200, 2100 and the usb - power - property - injection - for - sierra kUSBSleepPortCurrentLimit mentioned in kUSBSleepPowerSupply, kUSBWakePortCurrentLimit, kUSBWakePowerSupply the same meaning?
How do I determine if I'm fit for my own hardware device? I found a lot of patches written on the system specification 10.9.x 10.10.x! For example, I just added the BCM wifi patch for a few months to find out that no patch is needed, just install FakeID to get it done!
Every restart will appear "reboot. JPG" display content! Because of my poor English and the lack of understanding of computer terminology, I can't explain the problems I have encountered. Please help me understand these errors and failures. Thank you!