Ethernet Won't Work PLEASE HELP!!

[dobo9401]

So I tried putting the kext in /S/L/E, and then also in Clover. I would boot but no effect. Then I put it in just Clover, it would boot, but also no effect. When booting into Clover, it doesn't recognize any ethernet. (See Picture) I have tried everything that you have suggested, but to no result. It still works when booting up from my Unibeast drive. Any more suggestions? Also, when booting in verbose, I caught this. It didn't stop the boot, but it didn't look right. I said AppleIntelE1000e.kext (err) NVM Checksum is no valid. Could this be a problem?

 

[P1LGRIM]

So I tried putting the kext in /S/L/E, and then also in Clover. I would boot but no effect. Then I put it in just Clover, it would boot, but also no effect. When booting into Clover, it doesn't recognize any ethernet. (See Picture) I have tried everything that you have suggested, but to no result. It still works when booting up from my Unibeast drive. Any more suggestions? Also, when booting in verbose, I caught this. It didn't stop the boot, but it didn't look right. I said AppleIntelE1000e.kext (err) NVM Checksum is no valid. Could this be a problem?

You have a short memory - See Post #4

 

[Wilky13]

Dobo9401,

Did you ever get this sorted out? I had the same freeze/hang whether I uses EFI/Clover or S/L/E (and yes I used KextBeast, not just copied it into S/L/E). I finally got it to work by using MultiBeast, BUT now I have restart issues (see my post: http://www.tonymacx86.com/general-h...ele1000e-kext-causes-incomplete-restarts.html)