Contribute
Register

Eluktronics MAG-15 - Can't Boot Installer past "apfs_module_start"

Status
Not open for further replies.
Joined
Aug 26, 2011
Messages
16
Motherboard
HP Elite X2 G2
CPU
i5-7200U
Graphics
HD 620
Mac
  1. MacBook Pro
Classic Mac
  1. SE
Mobile Phone
  1. iOS
Hi all! I've got an Eluktronics MAG-15 (aka Element / Fusion 15 / QC7), and I can't seem to get it to boot into the installer. BIOS settings are all as recommended, thunderbolt is disabled, etc. No combination of options / disabling kexts seems to get me past the "apfs_module_start:1393" line.

Attached is the clover folder from the install USB with a DSDT dump done from within Clover.

Anyone got a clue or even vague direction to point me in? I used to hackintosh a lot back in the Sandy Bridge era, but modern PCs (and this being a laptop) seems to want to give me a new challenge.



IMG_6317.jpeg
 

Attachments

  • CLOVER.zip
    3 MB · Views: 75
Common problem - Search for 1393.
 
Common problem - Search for 1393.

Thanks! Found this post, got installer booting after following directions. Currently searching for a solution to the installation hanging at "About 2 minutes remaining" noticed this is normal behavior if the auto-reboot doesn't work...crossing fingers!
 
Status
Not open for further replies.
Back
Top