[Easy Guide] HD4600 hdmi audio for Gigabyte Series 8 with Clover-EFI booting and integrated graphics

[amgclk65]

[SUP]Im trying now. Im getting over 88 errors. Should i be booting with the boot flag null?
My broad has 892 audio. [/SUP]

 

[joncas]

[SUP]Im trying now. Im getting over 88 errors. Should i be booting with the boot flag null?
My broad has 892 audio. [/SUP]

I'm not knowledgeable enough to figure that out -- you better address this to Toleda's thread!

 

[mangosquash]

Thanks for this guide! I got it working on my media hackintosh my first try after struggling with other methods

 

[billyprefect]

So here is my take away from this write up:

Install Yosemite nice and fresh.
Copy over your reference EFI partition to the EFI partition - reboot.
Set the system to boot from UEFI.
Then simply run maciASL to patch the settings where required and voila - working system!

Here is my reality of this.
Install Yosemite, nice and fresh. got it.
Copy over the reference EFI to the EFI partition - good.
Reboot. ok.
Set the system to boot from UEFI. check.
Watch it hang.
Watch it not load.
Try to install Clover especially, based on the set up given. I can do this.
Watch it still fail to load. watch it fail to load from everything except the usb.
Get really mad at it.
Start over from Install Yosemite. REPEAT. Keep repeating until annoyed enough to respond to this post.

 

[joncas]

So here is my take away from this write up:

Install Yosemite nice and fresh.
Copy over your reference EFI partition to the EFI partition - reboot.
Set the system to boot from UEFI.
Then simply run maciASL to patch the settings where required and voila - working system!

Here is my reality of this.
Install Yosemite, nice and fresh. got it.
Copy over the reference EFI to the EFI partition - good.
Reboot. ok.
Set the system to boot from UEFI. check.
Watch it hang.
Watch it not load.
Try to install Clover especially, based on the set up given. I can do this.
Watch it still fail to load. watch it fail to load from everything except the usb.
Get really mad at it.
Start over from Install Yosemite. REPEAT. Keep repeating until annoyed enough to respond to this post.

The guide is for series 8 gigabyte -- your signature has a different board.
Also, try adding the -v bootflag to see where it hangs ...

 

[TanTaran]

This guide looks comprehensive enough, thanks for that

I was wondering if anyone tried it on 10.11.

Is it pretty much the same with Yosemite?