Contribute
Register

Current Multibeast Settings in Existing Build?

Status
Not open for further replies.
Joined
May 28, 2012
Messages
28
Motherboard
GA-Z77X-UD5H
CPU
Core i7 3770K
Graphics
GTX 560 Ti 1.25GB
Mac
  1. 0
Classic Mac
  1. 0
Mobile Phone
  1. 0
How can I check my current multibeast settings in existing build? I'm looking to buy a new hard drive, and I can't remember which options I chose in Multibeast when setting up my machine the last time around.

Thanks
flopperr999
 
How can I check my current multibeast settings in existing build? I'm looking to buy a new hard drive, and I can't remember which options I chose in Multibeast when setting up my machine the last time around.

Thanks
flopperr999
Why re-install on the new HDD?
Install HDD, run SuperDuper or CCC and clone to the new HDD, install Chimera, remove or reformat old drive (or keep as a bootable backup)
 
Chimera is installed through Multibeast yes? Having a hard time remembering
 
Chimera is installed through Multibeast yes? Having a hard time remembering

Unless you just want to install from scratch for some reason, you should follow Going Bald's suggestion and clone the installation over to your new drive, then run the standalone Chimera installer pointed at the new drive. I've done it this way and it works well.
 
Chimera is installed through Multibeast yes? Having a hard time remembering

You can select only Chimera in MultiBeast under boot loaders or you can download and use the stand alone installer. Either way works fine.
 
Status
Not open for further replies.
Back
Top