- Joined
- Mar 25, 2016
- Messages
- 2
- Motherboard
- GA-X58A-UD3R
- CPU
- Intel Core i7-930 2.80 GHz
- Graphics
- NVIDIA GeForce GTX 970 4GB
- Mac
- Classic Mac
- Mobile Phone
After I boot into the system, the only way I can make my line out work is when I unplug the cable and plug it again.
Is there any configuration to avoid that? Does it have some kind of "jack is connected" detection?
My sound board is a Creative Sound Blaster X-Fi Titanium, the system is El Capitan 10.11.3. I first installed the VoodooHDA 2.8.2 drivers from here, didn't seem to work, then I installed VoodooHDA v2.8.8 from MultiBeast over it (didn't know how to uninstall the previous one), didn't seem to work either, output was set to "Line-out (Green Rear)". Then I discovered the unplug/plug thing.
Is there any configuration to avoid that? Does it have some kind of "jack is connected" detection?
My sound board is a Creative Sound Blaster X-Fi Titanium, the system is El Capitan 10.11.3. I first installed the VoodooHDA 2.8.2 drivers from here, didn't seem to work, then I installed VoodooHDA v2.8.8 from MultiBeast over it (didn't know how to uninstall the previous one), didn't seem to work either, output was set to "Line-out (Green Rear)". Then I discovered the unplug/plug thing.