crash: Ethernet [IntelMausi]: I292V2 (Rev. 49)

[tof92130]

I am facing difficulties to update to MacOS Mojave and I don’t understand why so I join few screenshots.

It crashes at :

Ethernet [IntelMausi]: I292V2 (Rev. 49)

 

[tof92130]

A similar problem here but with Mac OS High Sierra

https://www.tonymacx86.com/threads/high-sierra-first-boot-stuck-at-ethernet-intelmausi.259597/

 

[tof92130]

In fact after that screen, it writes : "Still waiting for root device"

I am going to search on forum

 

[BreBo]

In fact after that screen, it writes : "Still waiting for root device"

"Still waiting for root device".
When installing this means that your USB flash drive cannot be found.
This is usually because the flash drive is in a USB3 port.
If this is the case move it to a USB2 port, if it is already in a USB2 port move it to another and try again.
Repeat until you have tried all USB ports.
Use a USB2 flash drive.
If it still doesn't work you could try another flash drive.
You might also try enabling Legacy on your USB3 ports in your BIOS settings.
If you only have USB3 ports try with your USB flash drive in a USB2 hub.
Make sure Fast Boot is not activated in your BIOS.

May require USBInjectAll.kext in /EFI/CLOVER/kexts/Other/.
May require XHCI-200-series-injector.kext in /EFI/CLOVER/kexts/Other/.
May need new patch for 10.14 to remove XHCI USB Port Limit to /Volumes/EFI/EFI/CLOVER/config.plist.

 

[tof92130]

Thank you

Yes it worked like that.
Now I am waiting for Nvidia drivers and to recover audio

"Still waiting for root device".
When installing this means that your USB flash drive cannot be found.
This is usually because the flash drive is in a USB3 port.
If this is the case move it to a USB2 port, if it is already in a USB2 port move it to another and try again.
Repeat until you have tried all USB ports.
Use a USB2 flash drive.
If it still doesn't work you could try another flash drive.
You might also try enabling Legacy on your USB3 ports in your BIOS settings.
If you only have USB3 ports try with your USB flash drive in a USB2 hub.
Make sure Fast Boot is not activated in your BIOS.

May require USBInjectAll.kext in /EFI/CLOVER/kexts/Other/.
May require XHCI-200-series-injector.kext in /EFI/CLOVER/kexts/Other/.
May need new patch for 10.14 to remove XHCI USB Port Limit to /Volumes/EFI/EFI/CLOVER/config.plist.

 

[BreBo]

Now I am waiting for Nvidia drivers and to recover audio

For audio see Mojave AppleHDA Audio

 

[tof92130]

For audio see Mojave AppleHDA Audio

Thank you, I will try that simple solution :

https://www.tonymacx86.com/threads/mojave-applehda-audio.260004/page-3#post-1815644

Removing realtekALC.kext
Installing AppleALC.kext

I am not sure that Lilu.kext is installed, I will see that this evening.