Clover Updated - Cannot Boot

[gonegolf]

Hi, accidentally updated Clover from 4289 to 5117 today and now the system cannot boot.

Stuck on the clover screen with only ability to use Shell 64.

Anyone with experience or help on how to reverse make this work again or reverse the update?

Thanks in advance

 

[P1LGRIM]

The folder structure has changed in the newer versions of Clover, drivers are now in a new location.
You can boot from a USB installer and install the missing drivers.

 

[floydian80]

I am in the same boat here. I created a USB installer for Catalina and it continues to loop boot into USB installer disk. Cannot get into my Mac SSD...

 

[gonegolf]

Thanks for the prompt responses.

After going through more posts, I found the following which is very good and detailed guide.

How to Update Clover v2.4k r4xxx to v2.5k r5xxx (v2.4k r4972 to v2.5 r5018 example)

I really like to update Clover every time I update to a new version of Mac OS to help prevent issues. For 10.14.6 however, the Clover update would not work. I eventually found out that there are changes in Clover v2.5k that do not allow simple updating from v2.4k – detailed in a post by Slice...

www.tonymacx86.com

Hopefully, it will be helpful to you.

In my case, lucky thing I found an old backup which I have been able to put back to use after after 2hours. However, I have not figured out how to make the changes to the old drive, yet. Hence slow response on the forums.

Nevertheless, you guys rock!