- Joined
- Aug 20, 2010
- Messages
- 100
- Motherboard
- Z370N
- CPU
- i7-8700K
- Graphics
- RX 580
Hello. Spent all day today trying to get my machine booted via Clover. I read the whole wiki and many posts on it but still having problems. Any help would be appreciated.
system:
Gigabyte H87N
i7-4771
gtx670
I created an install stick based on apamadeus's post in this forum. I could get into clover no problem but could never reach the installer so I installed OSX on an ssd using UniBeast to see if I could boot to that.
Either way, whatever I try, I am always stuck at [PCI Configuration Begin]
-Tried all types of boot flags including npci=0x1000,2000,3000, PCIRootUID=0,1
-Tried the simple barebones config that comes with Clover as a starting point as well as the default one that is more populated. Booted maybe a hundred times with different config options... This board should require minimal edits so I tried to keep it as simple as possible and work my way up. Nothing I did seemed to make a difference.
-Tried the drop DMAR table (my CPU has VT-d)
-I was able to boot the ssd twice using -x boot flag. A few times without -x it would get past the PCI Configuration Begin but freeze just after loading FakeSMC (this happens if I am injecting FakeSMC via Clover as well as if I install it once booted).
thanks for any help!
system:
Gigabyte H87N
i7-4771
gtx670
I created an install stick based on apamadeus's post in this forum. I could get into clover no problem but could never reach the installer so I installed OSX on an ssd using UniBeast to see if I could boot to that.
Either way, whatever I try, I am always stuck at [PCI Configuration Begin]
-Tried all types of boot flags including npci=0x1000,2000,3000, PCIRootUID=0,1
-Tried the simple barebones config that comes with Clover as a starting point as well as the default one that is more populated. Booted maybe a hundred times with different config options... This board should require minimal edits so I tried to keep it as simple as possible and work my way up. Nothing I did seemed to make a difference.
-Tried the drop DMAR table (my CPU has VT-d)
-I was able to boot the ssd twice using -x boot flag. A few times without -x it would get past the PCI Configuration Begin but freeze just after loading FakeSMC (this happens if I am injecting FakeSMC via Clover as well as if I install it once booted).
thanks for any help!