Contribute
Register

Can't reach Sierra installer

Status
Not open for further replies.
Joined
May 26, 2015
Messages
9
Motherboard
Gigabyte GA-Z97-D3H
CPU
i5-4460
Graphics
RX 580
Mac
  1. iMac
Mobile Phone
  1. iOS
Hey guys / girls

Decided to finally start with a complete fresh installation of Sierra (I'm still on 10.10.4).
Followed the step using this guide: https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.200564/
The bootable USB is made, but why I try to boot using the USB it doesn't reach the installer.
Entering verbose-mode gives me the following messages. Anyone of you that can help me in the right direction?
Clover folder is included as attachment.

Thx,
Jeroen

IMG_2614.JPG
 

Attachments

  • Clover.zip
    4.1 MB · Views: 39
Hey guys / girls

Decided to finally start with a complete fresh installation of Sierra (I'm still on 10.10.4).
Followed the step using this guide: https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.200564/
The bootable USB is made, but why I try to boot using the USB it doesn't reach the installer.
Entering verbose-mode gives me the following messages. Anyone of you that can help me in the right direction?
Clover folder is included as attachment.

Thx,
Jeroen

View attachment 263324

You have OsxAptioFixDrv & OsxAptioFixDrv2 in Drivers64UEFI. Never a good idea to have both. Try removing OsxAptioFixDrv leaving OsxAptioFixDrv2. FYI Drivers64UEFI is messy.
 
Status
Not open for further replies.
Back
Top