Can't reach install Menu with Core i7-4770k/GA-Z87X-UD3H (Following Nov Guide to DOT)

[pakiyabhai]

Stuck at IOBluetoohHCICController Error , i7-4770k/GA-Z87X-UD3H

Hello,

I'm following TonyMac December 2013 Guide to the Dot.

My config stands at Corei7-4770k , GA-Z87X-UD3H , 4 GB Ram , Internal Graphic card


I've updated the motherboard firmware to F7
I've made the following changes to BIOS .
Press F7, Loads Defaults - Yes
Under Peripherals > xHCI Mode, change it to AUTO
Under Peripherals > xHCI Hand-OFF, change it to ENABLED
Under Peripherals > EHCI Hand-OFF, Change it to Enabled

Under Peripherals > Initial Display Output -> IGFX since I'm not using any external graphics card

I made Maverick Installation using Unibeast as per the guide.

After restarting , I choose USB at the menu , apple symbol boots up and it hangs

I've tried booting with -x flag but still the same result.

I've tried booting with -v flag , and it stuck on
[IOBluetoohHCICController][start]--completed

Help?

 

[defbref]

Its usually a graphics problem, as thats the next thing after blutooth. What video output are you using? VGA is not supported.

 

[pakiyabhai]

OOh Thanks you , I was using VGA only . I'm going to get myself an HDMI wire tonight and experiment tomorrow with progress.

 

[pakiyabhai]

Update #1

SO I plugged in to HDMI , now I'm getting a new "Missing bluetooth controller transport!" error as well.

Update #2

I've tried putting a Sapphire Radeon 6950 card , still the same error

Update #3

With Sapphire 6950 card , I've turned internal graphic card off in bios , tried grahpicsEnabler=on/off combination along with -x , -v commands , I'm still stuck at same stage.


Any help?