Contribute
Register

Can't boot without safe mode after successful installation

Joined
Aug 14, 2010
Messages
14
Motherboard
Maximus VII Formula (Z97)
CPU
Intel i7-4770k
Graphics
GTX 780TI
Mac
MacBook Pro
Classic Mac
Mobile Phone
iOS
This is a new build with the following components:

Motherboard: Asus Maximus VII Hero (Z97 Chipset)
CPU: Intel Core i7-4770k
Memory: 24GB DDR3-2400 RAM (F3-2400C10D-16GTX, 3 sticks)
Graphics: Integrated Graphics from the 4770k (I will install card after a successful boot)

I was able to run the installer UniBeast generated from 10.9.4 without any boot flags. When I went to actually boot though, It spun forever. In verbose mode there are a few peculiar lines such as:
"SMC::smcInitHelper ERROR: MMIO regMap == NULL - fall back to old SMC mode"
"ACPI_SMC_PlatformPlugin::start - waitForService(resourceMatching(AppleIntelCPUPowerManagement) timed out"
"WARNING: IOPlatformPluginUtil: getCPUIDInfo: this is an unknown CPU model 0x3c -- power management may be incomplete or unsupported"

Ultimately though it continues with lines like "init", "probe", "start", "DSMOS has ariived" until it eventually says:
"flow_divert_kctl_disconnect (0): disconnecting group 1"
"flow_divert_kctl_disconnect (0): disconnecting group 1"
"DRMStatus: iTunes/Apple Store Content Access Problem. Content playback may be disabled...etc"

And then it hangs. No kernel panic, it just stays there forever. Booting with -x works fine, and I have tried booting without -x both before AND after installing multibeast kexts. The messages are the same both ways.

Does anyone have any ideas? Thanks in advance!

Edit: Not sure if it is worth noting, but single user mode (-s) works as well.

Edit 2: I've uploaded a picture of the verbose screen. Sorry for the bad quality. http://clfu.se/rK8
 
Top